Operation Manual

System Services Commands

Mobility System Software Command Reference Guide

Version 7.3

4 – 36

Examples

To store the location of the MX in the configuration, type the following command:

MX# set system location first-floor-bldg3

success: change accepted.

See Also

● clear system on page 4-21

● set system contact on page 4-30

● set system name on page 4-36

● show system on page 4-40

set system name

Changes the name of the MX from the default system name and also provides content for the CLI

prompt, if you do not specify a prompt.

Syntax

set system name string

Defaults

By default, the system name and command prompt have the same value. The factory

default for both is MX-mm-nnnnnn, where mm is the model number and nnnnnn is the last 6 digits

of the 12-digit system MAC address.

Access

Enabled.

History

Introduced in MSS Version 1.0.

Usage

Entering set system name with no string resets the system name to the factory default.

To view the system name string, type the show system command.

Examples

The following example sets the system name to a name that identifies the MX switch:

MX# set system name MX-bldg3

success: change accepted.

MX-bldg3#