Operation Manual
MP Access Point Commands
Mobility System Software Command Reference Guide
Version 7.3
12 – 312
set service-profile tkip-mc-time
Changes the length of time that MP radios use countermeasures if two message integrity code
(MIC) failures occur within 60 seconds. When countermeasures are in effect, MP radios dissociate
all TKIP and WPA WEP clients and refuse all association and reassociation requests until the
countermeasures end.
Syntax
set service-profile profile-name tkip-mc-time wait-time
Defaults
The default countermeasures wait time is 60,000 ms (60 seconds).
Access
Enabled.
History
Introduced in MSS Version 3.0.
Usage
Countermeasures apply only to TKIP and WEP clients. This includes WPA WEP clients
and non-WPA WEP clients. CCMP clients are not affected.
The TKIP cipher suite must be enabled. The WPA IE also must be enabled.
Examples
The following command changes the countermeasures wait time for service profile sp3
to 30,000 ms (30 seconds):
MX# set service-profile sp3 tkip-mc-time 30000
success: change accepted.
See Also
● set service-profile [rsn-ie | wpa-ie] cipher-tkip on page 12-293
● set service-profile wpa-ie on page 12-321
● show service-profile on page 12-357
set service-profile transmit-rates
Changes the data rates supported by MP radios for a service-profile SSID.
Syntax
set service-profile profile-name transmit-rates {11a | 11b | 11g | 11na |
11ng} mandatory rate-list [disabled rate-list] [beacon-rate rate] [multicast-rate
{rate | auto}]
profile-name Service profile name.
tkip-mc-time Number of milliseconds (ms) countermeasures remain in
effect. You can specify from 0 to 60,000.
profile-name Service profile name.
11a | 11b | 11g | 11na
| 11ng
Radio type.