Operation Manual

MP Access Point Commands
MP Access Point Commands
12 – 299
Examples The following command changes the long retry threshold for service profile sp1 to 8:
MX# set service-profile sp1 long-retry-count 8
success: change accepted.
See Also
● set radio-profile frag-threshold on page 12-271
● set service-profile short-retry-count on page 12-304
● show service-profile on page 12-357
set service-profile max-bw
Configures the maximum bandwidth for a service profile.
Syntax set service-profile profile-name max-bw max-bw-kb
Defaults None
Access Enabled
History Added in MSS Version 7.0.
Usage Use this command to configure specific bandwidth requirements for a service profile. Once
configured, the service profile can be mapped to a specific radio profile.
set service-profile mesh
Creates a service profile for use with WLAN mesh services.
Syntax set service-profile name mesh mode {enable | disable}
Defaults None.
Access Enabled.
History Introduced in MSS Version 6.0.
Usage Use this command to configure mesh services for a service profile. Once configured, the
service profile can then be mapped to a radio profile that manages a radio on the Mesh Portal MP,
which then allows a Mesh Portal AP to beacon a mesh services SSID to Mesh APs.
Examples The following command enables mesh services for service profile sp1:
MX# set service-profile sp1 mesh mode enable
success: change accepted.
profile-name
Name of the service profile.
max-bw-kb
Configure a bandwidth from 1-300000 Kbps. 0 =
unlimited bandwith
name Service profile name.
enable Enables mesh services for the service profile.
disable Disables mesh services for the service profile.