Operation Manual

MP Access Point Commands
Mobility System Software Command Reference Guide
Version 7.3
12 – 298
See Also show service-profile on page 12-357
set service-profile load-balancing-exempt
Exempts a service profile from performing RF load balancing.
Syntax set service-profile profile-name load-balancing-exempt {enable | disable}
Defaults By default, MP radios automatically perform RF load balancing for all service profiles.
Access Enabled.
History Introduced in MSS Version 6.0.
Usage Use this command to exempt a service profile from RF load balancing. Exempting a
service profile from RF load balancing means that if an MP radio is attempting to steer clients
away, the radio does not reduce or conceal the availability of the SSID named in the exempted
service profile. Even if a radio is withholding probe responses to manage the load, the radio does
respond to probes for an exempt SSID. Also, if an MP radio is withholding probe responses, and a
client probes for any SSID, and the radio has at least one exempt SSID, the radio responds to the
probe, but the response reveals only the exempt SSID(s).
Examples The following command exempts service profile sp3 from RF load balancing:
MX# set service-profile sp3 load-balancing-exempt enable
success: change accepted.
See Also
● set load-balancing strictness on page 12-259
● set ap radio load-balancing on page 12-251
● set ap local-switching mode on page 12-244
● show load-balancing group on page 12-353
set service-profile long-retry-count
Changes the long retry threshold for a service profile. The long retry threshold specifies the
number of times a radio can send a long unicast frame without receiving an acknowledgment. A
long unicast frame is a frame that is equal to or longer than the frag-threshold.
Syntax set service-profile name long-retry-count threshold
Defaults The default long unicast retry threshold is 5 attempts.
Access Enabled.
History Introduced in MSS Version 4.2.
profile-name Service profile name.
enable Exempts the specified service profile from RF load balancing.
disable If a service profile has previously been exempted from RF load balancing,
restores RF load balancing for the service profile.
name Service profile name.
threshold Number of times the radio can send the same long unicast frame. You can
enter a value from 1 through 15.