Operation Manual

MP Access Point Commands
MP Access Point Commands
12 – 293
set service-profile [rsn-ie | wpa-ie] cipher-tkip
Disables or reenables Temporal Key Integrity Protocol (TKIP) encryption in a service profile.
Syntax set service-profile name [ rsn-ie | wpa-ie] cipher-tkip {enable | disable}
Defaults When RNS IE or WPA IE is enabled, you can enable TKIP encryption. It is disabled by
default.
Access Enabled.
History
Usage
To use TKIP, you must also enable the WPA IE.
Examples The following command disables TKIP encryption in service profile sp2:
MX# set service-profile sp2 wpa-ie cipher-tkip disable
success: change accepted.
See Also
● set service-profile [rsn-ie | wpa-ie ]cipher-ccmp on page 12-292
● set service-profile [rsn-ie | wpa-ie] cipher-wep104 on page 12-293
● set service-profile [rsn-ie | wpa-ie ] cipher-wep40 on page 12-294
● set service-profile tkip-mc-time on page 12-312
● set service-profile wpa-ie on page 12-321
● show service-profile on page 12-357
set service-profile [rsn-ie | wpa-ie] cipher-wep104
Enables dynamic Wired Equivalent Privacy (WEP) with 104-bit keys, in a service profile.
Syntax set service-profile name [rsn-ie | wpa-ie] cipher-wep104 {enable | disable}
Defaults 104-bit WEP encryption is disabled by default.
Access Enabled.
name Service profile name.
enable Enables TKIP encryption for RSN or WPA clients.
disable Disables TKIP encryption for RSN or WPA clients.
MSS Version 3.0 Command introduced.
MSS Version 7.1 Moved command to rsn-ie and wpa-ie as part of
the mixed cipher feature.
name Service profile name.
enable Enables 104-bit WEP encryption for RSN or WPA clients.
disable Disables 104-bit WEP encryption for RNS or WPA
clients.