Operation Manual

MP Access Point Commands
MP Access Point Commands
12 – 291
Syntax set service-profile profile-name cac-mode {none | session | voip-call}
Defaults The default CAC mode is none.
Access Enabled.
History
Examples The following command enables session-based CAC on service profile sp1:
MX# set service-profile sp1 cac-mode session
success: change accepted.
See Also
● set service-profile cac-session on page 12-291
● show service-profile on page 12-357
set service-profile cac-session
Specifies the maximum number of active sessions a radio can have when session-based CAC is
enabled. When an MP radio has reached the maximum allowed number of active sessions, the
radio refuses connections from additional clients.
Syntax set service-profile profile-name cac-session max-sessions
Defaults The default number of sessions allowed is 14.
Access Enabled.
History Introduced in MSS Version 4.2.
Usage This command applies only when the CAC mode is session. If the CAC mode is none, you
can still change the maximum number of sessions, but the setting does not take effect until you
change the CAC mode to session. To change the CAC mode, use the set service-profile
cac-mode command.
Examples The following command changes the maximum number of sessions for radios used by
service profile sp1 to 10:
MX# set service-profile sp1 cac-session 10
success: change accepted.
See Also
● set service-profile cac-mode on page 12-290
● show service-profile on page 12-357
profile-name Service profile name.
none CAC is not used.
session CAC is based on the number of active sessions.
voip-call CAC is based on VoIP calls.
MSS Version 4.2 Command introduced.
MSS Version 7.1 Added option voip-call.
profile-name Service profile name.
max-sessions Maximum number of active sessions allowed on the
radio.