Operation Manual

MP Access Point Commands
MP Access Point Commands
12 – 289
set service-profile [rsn-ie | wpa-ie] auth-psk
Enables pre-shared key (PSK) authentication of Wi-Fi Protected Access (WPA) clients by MP
radios in a radio profile, when the WPA information element (IE) is enabled in the service profile.
Syntax
set service-profile name [rsn-id | wpa-ie] auth-psk {enable | disable}
Defaults
When the WPA IE is enabled, PSK authentication of WPA clients is enabled by default.
If the WPA IE is disabled, the auth-psk setting has no effect.
Access
Enabled.
History
Introduced in MSS Version 3.0.
Usage
This command affects authentication of WPA clients only.
To use PSK authentication, you also must configure a passphrase or key. In addition, you must
enable the WPA IE.
Examples
The following command enables PSK authentication for service profile wpa_clients:
MX# set service-profile wpa_clients auth-psk enable
success: change accepted.
See Also
set service-profile [rsn-ie | wpa-ie] auth-dot1x on page 12-287
set service-profile [rsn-ie | wpa-ie] psk-raw on page 12-302
set service-profile wpa-ie on page 12-321
show service-profile on page 12-357
set service-profile beacon
Disables or reenables beaconing of the SSID managed by the service profile.
An MP radio responds to an 802.11 probe any request with only the beaconed SSID(s). For a
nonbeaconed SSID, radios respond only to directed 802.11 probe requests that match the
nonbeaconed SSID’s SSID string.
When you disable beaconing for an SSID, the radio still sends beacon frames, but the SSID name
in the frames is blank.
Syntax
set service-profile name beacon {enable | disable}
Defaults
Beaconing is enabled by default.
Access
Enabled.
History
Introduced in MSS Version 3.0.
name Service profile name.
enable Enables PSK authentication of WPA clients.
disable Disables PSK authentication of WPA clients.
name Service profile name.
enable Enables beaconing of the SSID managed by the service
profile.
disable Disables beaconing of the SSID managed by the service
profile.