Operation Manual

ManualsBrandsTrapeze smart mobile ManualsSoftwareMobility System Software 7.3

281

282

283

284

285

286

287

288

289

290

MP Access Point Commands

Mobility System Software Command Reference Guide

Version 7.3

12 – 284

Syntax

set radio-profile profile-name snoop snoop-filter

Defaults

None

Access

Enabled

History

Added in MSS Version 7.0.

set radio-profile wmm

Deprecated in MSS Version 4.2. To enable or disable WMM, see set radio-profile qos-mode on

page 12-275.

set radio-profile wmm-powersave

Enables Unscheduled Automatic Powersave Delivery (U-APSD) on MP radios managed by the

radio profile. U-APSD enables WMM clients that use powersave mode to more efficiently request

buffered unicast packets from MP radios.

When U-APSD is enabled, a client can retrieve buffered unicast packets for a traffic priority

enabled for U-APSD by sending a QoS data or QoS-Null frame for that priority. U-APSD can be

enabled for individual traffic priorities, for individual clients, based on the client’s request. A

client enables U-APSD for a traffic priority by indicating this preference when (re)associating

with the MP radio.

A client can but is not required to request U-APSD for all four traffic priorities. The MP radio still

buffers packets for all traffic priorities even if the client does not request U-APSD for them.

However, to retrieve buffered packets for priorities not using U-APSD, a client must send a

separate PSpoll for each buffered packet.

Syntax

set radio-profile name wmm-powersave {enable | disable}

Defaults

U-APSD is disabled by default.

Access

Enabled.

History

Introduced in MSS Version 5.0.

Usage

U-APSD is supported only for QoS mode WMM. If WMM is not enabled on the radio

profile, use the set radio-profile qos-mode command to enable it.

Examples

The following command enables U-APSD on radio profile rp1:

MX# set radio-profile rp1 wmm-powersave enable

success: change accepted.