Operation Manual

MP Access Point Commands
Mobility System Software Command Reference Guide
Version 7.3
12 – 282
Access Enabled.
History Introduced in MSS Version 3.0.
Usage You must configure the service profile before you can map it to a radio profile. You can
map the same service profile to more than one radio profile.
You must disable all radios that use a radio profile before you can change parameters in the
profile. Use the set radio-profile mode command .
Examples The following command maps service-profile wpa_clients to radio profile rp2:
MX# set radio-profile rp2 service-profile wpa_clients
success: change accepted.
See Also
● set service-profile attr on page 12-286
user-idle-timeout 180 Allows a client to remain idle for 180 seconds (3
minutes) before MSS changes the client’s session to
the Disassociated state.
web-portal-acl portalacl
Note: This is the
default only if the
fallthru type on
the service profile
has been set to
web-portal.
Otherwise, the
value is
unconfigured.
If set to portalacl and the service profile fallthru is
set to web-portal, radios use the portalacl ACL to
filter traffic for Web Portal users during
authentication.
If the fallthru type is web-portal but
web-portal-acl is set to an ACL other than
portalacl, the other ACL is used.
If the fallthru type is not web-portal, radios do not
use the web-portal-acl setting.
web-portal-form Not configured For WebAAA users, serves the Trapeze Networks
login page.
web-portal-logout none If set to logout-url, you can define a custom URL
that allows a client to log out of the network. To
enable this feature, use the mode option and then
enable.
web-portal-session-
timeout
5 Allows a Web Portal WebAAA session to remain in
the Deassociated state 5 seconds before being
terminated automatically.
wep key-index No keys defined Uses dynamic WEP rather than static WEP.
Note: If you configure a WEP key for static WEP,
MSS continues to also support dynamic WEP.
wep
active-multicast-ind
ex
1 Uses WEP key 1 for static WEP encryption of
multicast traffic if WEP encryption is enabled and
keys are defined.
wep
active-unicast-index
1 Uses WEP key 1 for static WEP encryption of
unicast traffic if WEP encryption is enabled and
keys are defined.
wpa-ie disable Does not use the WPA IE in transmitted frames.
Version 3.0 Command introduced.
Version 7.0 The option static-cos was removed.
Table 12– 4. Defaults for Service Profile Parameters (continued)
Parameter Default Value Radio Behavior When Parameter Set To Default Value