Operation Manual

MP Access Point Commands
MP Access Point Commands
12 – 281
mesh none Enables mesh mode on the network.
proxy-arp disable Does not reply on behalf of wireless clients to ARP
requests for client IP addresses. Instead, the radio
forwards the ARP Requests as wireless broadcasts.
psk-encrypted none Sets an encrypted preshared key.
psk-phrase No passphrase
defined
Uses dynamically generated keys rather than
statically configured keys to authenticate WPA
clients.
psk-raw No preshared key
defined
Uses dynamically generated keys rather than
statically configured keys to authenticate WPA
clients.
rsn-ie disable Does not use the RSN IE in transmitted frames.
(The RSN IE is required for 802.11i. RSN is
sometimes called WPA2.)
shared-key-auth disable Does not use shared-key authentication.
This parameter does not enable PSK
authentication for WPA. To enable PSK encryption
for WPA, use the set radio-profile auth-psk
command.
short-retry-count 5 Sends a short unicast frame up to five times
without acknowledgment.
soda disable Sygate On Demand Agent (SODA) files are not
downloaded to connecting clients.
ssid-name trapeze Uses the SSID name trapeze.
ssid-type crypto Encrypts wireless traffic for the SSID.
tkip-mc-time 60000 Uses Michael countermeasures for 60,000 ms (60
seconds) following detection of a second MIC failure
within 60 seconds.
transmit-rates 802.11a:
❑ mandatory:
6.0,12.0,24.0
❑ beacon-rate: 6.0
❑ multicast-rate:
auto
❑ disabled: none
802.11b:
❑ mandatory:
1.0,2.0
❑ beacon-rate: 2.0
❑ multicast-rate:
auto
❑ disabled: none
802.11g:
❑ mandatory:
1.0,2.0,5.5,11.0
❑ beacon-rate: 2.0
❑ multicast-rate:
auto
❑ disabled: none
Accepts associations only from clients that support
one of the mandatory rates.
Sends beacons at the specified rate (6 Mbps for
802.11a, 2 Mbps for 802.11b/g).
Sends multicast data at the highest rate that can
reach all clients connected to the radio.
Accepts frames from clients at all valid data rates.
(No rates are disabled by default.)
Table 12– 4. Defaults for Service Profile Parameters (continued)
Parameter Default Value Radio Behavior When Parameter Set To Default Value