Operation Manual

MP Access Point Commands
Mobility System Software Command Reference Guide
Version 7.3
12 – 280
auth-fallthru none Denies access to users who do not match an 802.1X
or MAC authentication rule for the SSID requested
by the user.
auth-psk disable Does not support using a preshared key (PSK) to
authenticate WPA clients.
beacon enable Sends beacons to advertise the SSID managed by
the service profile.
bridging none Supports bridging between MPs
cac-mode none Does not limit the number of active user sessions
based on Call Admission Control (CAC).
cac-session 14 If session-based CAC is enabled (cac-mode is set
to session), limits the number of active user
sessions on a radio to 14.
cipher-ccmp disable Does not use Counter with Cipher Block Chaining
Message Authentication Code Protocol (CCMP) to
encrypt traffic sent to WPA clients.
cipher-tkip enable When the WPA IE is enabled, uses Temporal Key
Integrity Protocol (TKIP) to encrypt traffic sent to
WPA clients.
cipher-wep104 disable Does not use Wired Equivalent Privacy (WEP) with
104-bit keys to encrypt traffic sent to WPA clients.
cipher-wep40 disable Does not use WEP with 40-bit keys to encrypt
traffic sent to WPA clients.
cos 0 If static CoS is enabled (static-cos is set to
enable), assigns CoS 0 to all data traffic to or from
clients.
dhcp-restrict disable Does not restrict a client’s traffic to only DHCP
traffic while the client is being authenticated and
authorized.
idle-client-probing enable Sends a keepalive packet (a null-data frame) to
each client every 10 seconds.
keep-initial-vlan disable Reassigns the user to a VLAN after roaming,
instead of leaving the roamed user on the VLAN
assigned by the switch where the user logged on.
Note:
Enabling this option does not retain the initial
VLAN assignment for a user in all cases. (For
information, see “set service-profile
keep-initial-vlan” on page 12–297
.)
load-balancing-exe
mpt
none Exempts the service profile from load balancing.
long-retry-count 5 Sends a long unicast frame up to five times without
acknowledgment.
no-broadcast disable Does not reduce wireless broadcast traffic by
sending unicasts to clients for ARP requests and
DHCP Offers and Acks instead of forwarding them
as multicasts.
max-bw none Sets the service profile bandwidth limit from 1 to
300000 Kbps. 0 equals unlimited bandwidth.
Table 12– 4. Defaults for Service Profile Parameters (continued)
Parameter Default Value Radio Behavior When Parameter Set To Default Value