Operation Manual

MP Access Point Commands
Mobility System Software Command Reference Guide
Version 7.3
12 – 278
set radio-profile rf-scanning mode
Configures RF scanning mode in active or passive states.
Syntax set radio-profile profile-name rf-scanning mode [passive | active]
Defaults None
Access Enabled
History Added in MSS Version 6.2
Examples To configure active rf-scanning mode for radio profile gofish, use the following
command:
MX> set radio-profile gofish rf-scanning mode active
success: change accepted.
set radio-profile rfid-mode
Enables MP radios managed by a radio profile to function as location receivers in an AeroScout
Visibility System. An AeroScout Visibility System allows system administrators to track mobile
assets using RFID tags.
When you enable RFID mode on a radio profile, radios in the profile can receive and process
signals transmitted by RFID tags and relay them with related information to the AeroScout
Engine. If the floor plan is modeled in RingMaster, you also can use RingMaster to display the
locations of assets.
Syntax set radio-profile profile-name rfid-mode {enable | disable}
Defaults The default is disable.
Access Enabled.
History Introduced in MSS Version 5.0.
Examples The following command enables radios managed by radio profile rp1 to act as asset
location receivers:
MX# set radio-profile rfid-mode enable
success: change accepted.
See Also
● set radio-profile mode on page 12-272
● show radio-profile on page 12-354
passive The radio scans once per predefined time and
audits the packets on the wireless network. The
default time is 1 second.
active The radio actively sends probes to other
channels and then audits the packets on the
wireless network.
profile-name Radio profile name.
enable Enables radios to function as asset location receivers.
disable Disables radios from functioning as asset location
receivers.