Operation Manual

MP Access Point Commands
MP Access Point Commands
12 – 277
You can use this command to enforce the data rates, which means that a connecting client must
transmit at one of the mandatory or standard rates in order to associate with the MP. When data
rate enforcement is enabled, clients transmitting at the disabled rates are not allowed to associate
with the MP.
This command is useful if you want to completely prevent clients from transmitting at disabled
data rates. For example, you can disable slower data rates so that clients transmitting at these
rates do not consume bandwidth on the channel at the expense of clients transmitting at faster
rates.
Examples The following command enables data rate enforcement for radio profile rp1:
MX# set radio-profile rp1 rate-enforcement mode enable
success: change accepted.
See Also
● set service-profile transmit-rates on page 12-312
● show ap counters on page 12-330
set radio-profile rf-scanning channel-scope
Configures the channel-scope for RF scanning.
Syntax set radio-profile profile-name rf-scanning channel-scope
[operating|regulatory|all]
Defaults None
Access Enabled
History Added in MSS Version 6.2.
Examples To scan only operating channels on radio profile, gofish, use the following command:
MX> set radio-profile gofish rf-scanning channel-scope operating
success: change accepted.
set radio-profile rf-scanning cts-to-self
Configures RF scanning to send CTS packets before going to another channel.
Syntax set radio-profile name rf-scanning cts-to-self [enable | disable]
Defaults None
Access Enabled
History Added in MSS 7.3
Examples To enable a radio profile to send CTS packets, use the following command:
MX# set radio-profile corp1 rf-scanning cts-to-self enable
success: change accepted.
regulatory Scans and audits regulatory channels for
802.11a or 802.11b/g.
operating Scans and audits the current channel.
all Scans and audits all channels on the radio.