Operation Manual

MP Access Point Commands
MP Access Point Commands
12 – 273
Access Enabled.
Table 12– 3. Defaults for Radio Profile Parameters
Parameter Default Value Radio Behavior When Parameter Set To Default Value
active-scan enable Sends probe any requests (probe requests with a
null SSID name) to solicit probe responses from
other access points.
auto-tune enable Allows dynamic configuration of channel and
power settings by MSS.
beacon-interval 100 Waits 100 ms between beacons.
countermeasures Not
configured
Does not issue countermeasures against any
device.
dtim-interval 1 Sends the delivery traffic indication map (DTIM)
after every beacon.
frag-threshold 2346 Uses the short-retry-count for frames shorter
than 2346 bytes and uses the long-retry-count for
frames that are 2346 bytes or longer.
max-rx-lifetime 2000 Allows a received frame to stay in the buffer for
up to 2000 ms (2 seconds).
max-tx-lifetime 2000 Allows a frame that is scheduled for
transmission to stay in the buffer for up to
2000 ms (2 seconds).
preamble-length short Advertises support for short 802.11b preambles,
accepts either short or long 802.11b preambles,
and generates unicast frames with the preamble
length specified by the client.
Note: This parameter applies only to 802.11b/g
radios.
qos-mode wmm Classifies and marks traffic based on 802.1p and
DSCP, and optimizes forwarding prioritization of
MP radios for Wi-Fi Multimedia (WMM).
rfid-mode disable Radio does not function as a location receiver in
an AeroScout Visibility System.
rts-threshold 2346 Transmits frames longer than 2346 bytes by
means of the Request-to-Send/Clear-to-Send
(RTS/CTS) method.
service-profile No service
profiles
defined
You must configure a service profile. The service
profile sets the SSID name and other
parameters.
wmm-powersave disable Requires clients to send a separate PSpoll to
retrieve each unicast packet buffered by the MP
radio.