Operation Manual

MP Access Point Commands
MP Access Point Commands
12 – 269
Syntax set radio-profile profile-name countermeasures {all | rogue | none}
Defaults Countermeasures are disabled by default.
Access Enabled.
History
Examples
The following command enables countermeasures in radio profile radprof3 for rogues
only:
MX# set radio-profile radprof3 countermeasures rogue
success: change accepted.
The following command disables countermeasures in radio profile radprof3:
MX# clear radio-profile radprof3 countermeasures
success: change accepted.
The following command causes radios managed by radio profile radprof3 to issue countermeasures
against devices in the MX switch’s attack list:
MX# set radio-profile radprof3 countermeasures configured
success: change accepted.
Note that when you issue this command, countermeasures are then issued only against devices in
the MX attack list, not against other devices that were classified as rogues by other means.
set radio-profile dfs-channels
Enables the use of DFS channels to meet regulatory requirements.
Syntax set radio-profile profile-name dfs-channels {enable | disable}
Defaults Disabled
Access Enabled
History Introduced in MSS 7.0.
profile-name
Radio profile name.
all
Configures radios to attack rogues and interfering
devices.
rogue
Configures radios to attack rogues only.
none
Disables countermeasures for this radio profile.
Version 4.0 Command introduced.
Version 4.1 New option configured added to support
on-demand countermeasures.
Version 7.0 The option configured was removed.
MSS 7.0 Command introduced.