Operation Manual

MP Access Point Commands
Mobility System Software Command Reference Guide
Version 7.3
12 – 266
● show radio-profile on page 12-354
set radio-profile auto-tune power-ramp-interval
Changes the interval at which power is increased or decreased, in 1 dBm increments, on radios in
a radio profile until the optimum power level calculated by RF Auto-Tuning is reached.
Syntax set radio-profile profile-name auto-tune power-ramp-interval seconds
Defaults The default interval is 60 seconds.
Access Enabled.
History Introduced in MSS Version 5.0.
Examples The following command changes the power ramp interval for radios in radio profile rp2
to 120 seconds:
MX# set radio-profile rp2 auto-tune power-ramp-interval 120
success: change accepted.
See Also
● set ap radio auto-tune max-power on page 12-248
● set radio-profile auto-tune power-config on page 12-264
● set radio-profile auto-tune power-interval on page 12-264
● set radio-profile auto-tune power-lockdown on page 12-265
● show radio-profile on page 12-354
set radio-profile beacon-interval
Changes the rate at which each MP radio in a radio profile advertises a service set identifier
(SSID).
Syntax set radio-profile profile-name beacon-interval interval
Defaults The beacon interval for MP radios is 100 ms by default.
Access Enabled.
History Introduced in MSS Version 1.0.
Usage You must disable all radios that are using a radio profile before you can change
parameters in the profile. Use the set radio-profile mode command .
Examples The following command changes the beacon interval for radio profile rp1 to 200 ms:
MX# set radio-profile rp1 beacon-interval 200
success: change accepted.
profile-name Radio profile name.
seconds Number of seconds MSS waits before increasing or decreasing radio power by
another 1 dBm. You can specify from 1 to 65535.
profile-name Radio profile name.
interval Number of milliseconds (ms) between beacons. You can specify from 25 ms to
8191 ms.