Operation Manual

MP Access Point Commands
MP Access Point Commands
12 – 265
Syntax set radio-profile name auto-tune power-interval seconds
Defaults The default power tuning interval is 600 seconds.
Access Enabled.
History Introduced in MSS Version 3.0.
Examples The following command sets the power interval for radios in radio profile rp2 to 240
seconds:
MX# set radio-profile rp2 auto-tune power-interval 240
success: change accepted.
See Also
● set ap radio auto-tune max-power on page 12-248
● set radio-profile auto-tune power-config on page 12-264
● set radio-profile auto-tune power-lockdown on page 12-265
● set radio-profile auto-tune power-lockdown on page 12-265
● set radio-profile auto-tune power-ramp-interval on page 12-266
● show service-profile on page 12-357
set radio-profile auto-tune power-lockdown
Locks down the current power settings on all radios in a radio profile. The power settings that are
in effect when the command is entered are changed into statically configured power settings on the
radios. RF Auto-Tuning of power is then disabled in the radio profile.
Syntax set radio-profile name auto-tune power-lockdown
Defaults By default, when RF Auto-Tuning of power is enabled, power settings continue change
dynamically based on network conditions.
Access Enabled.
History Introduced in MSS Version 5.0.
Usage To save this command and the static power configuration commands created when you
enter this command, save the configuration.
Examples The following command locks down the power settings for radios in radio profile rp2:
MX# set radio-profile rp2 auto-tune power-lockdown
success: change accepted.
See Also
● set ap radio auto-tune max-power on page 12-248
● set radio-profile auto-tune channel-lockdown on page 12-263
● set radio-profile auto-tune power-config on page 12-264
● set radio-profile auto-tune power-interval on page 12-264
● set radio-profile auto-tune power-ramp-interval on page 12-266
name Radio profile name.
seconds Number of seconds MSS waits before changing radio power levels to adjust to
RF changes, if needed. You can specify from 1 to 65535 seconds.
name Radio profile name.