Operation Manual

MP Access Point Commands

12 – 263

Examples

The following command sets the channel interval for radios in radio profile rp2 to 2700

seconds (45 minutes):

MX# set radio-profile rp2 auto-tune channel-interval 2700

success: change accepted.

See Also

● set radio-profile auto-tune 11a-channel-range on page 12-260

● set radio-profile auto-tune channel-holddown on page 12-261

● set radio-profile auto-tune channel-lockdown on page 12-263

● show radio-profile on page 12-354

set radio-profile auto-tune channel-lockdown

Locks down the current channel settings on all radios in a radio profile. The channel settings that

are in effect when the command is entered are changed into statically configured channel

assignments on the radios. RF Auto-Tuning of channels is then disabled in the radio profile.

Syntax

set radio-profile profile-name auto-tune channel-lockdown

Defaults

By default, when RF Auto-Tuning of channels is enabled, channels continue to be

changed dynamically based on network conditions.

Access

Enabled.

History

Introduced in MSS Version 5.0.

Usage

To save this command and the static channel configuration commands created when you

enter this command, save the configuration.

Examples

The following command locks down the channel settings for radios in radio profile rp2:

MX# set radio-profile rp2 auto-tune channel-lockdown

success: change accepted.