Operation Manual
MP Access Point Commands
Mobility System Software Command Reference Guide
Version 7.3
12 – 262
Syntax
set radio-profile profile-name auto-tune channel-holddown holddown
Defaults
The default RF Auto-Tuning channel holddown is 900 seconds.
Access
Enabled.
History
Introduced in MSS Version 3.0.
Usage
The channel holddown applies even if RF anomalies occur that normally cause an
immediate channel change.
Examples
The following command changes the channel holddown for radios in radio profile rp2 to
600 seconds:
MX# set radio-profile rp2 auto-tune channel-holddown 600
success: change accepted.
See Also
● set radio-profile auto-tune 11a-channel-range on page 12-260
● set radio-profile auto-tune channel-interval on page 12-262
● set radio-profile auto-tune channel-lockdown on page 12-263
● show radio-profile on page 12-354
set radio-profile auto-tune channel-interval
Sets the interval at which RF Auto-Tuning decides whether to change the channels on radios in a
radio profile. At the end of each interval, MSS processes the results of the RF scans performed
during the previous interval, and changes radio channels if needed.
Syntax
set radio-profile profile-name auto-tune channel-interval seconds
Defaults
The default channel interval is 3600 seconds (one hour).
Access
Enabled.
History
Introduced in MSS Version 3.0.
Usage
It is recommended to use an interval of at least 300 seconds (5 minutes).
RF Auto-Tuning can change a radio channel before the channel interval expires in response to RF
anomalies. Even in this case, channel changes cannot occur more frequently than the channel
holddown interval.
If you set the interval to 0, RF Auto-Tuning does not reevaluate the channel at regular intervals.
However, RF Auto-Tuning can still change the channel in response to RF anomalies.
profile-name Radio profile name.
rate Minimum number of seconds a radio must remain on its current channel
setting before RF Auto-Tuning is allowed to change the channel. You can
specify from 0 to 65535 seconds.
profile-name Radio profile name.
seconds Number of seconds RF Auto-Tuning waits before changing radio channels
to adjust to RF changes, if needed. You can specify from 30 to 65535
seconds.