Operation Manual
MP Access Point Commands
MP Access Point Commands
12 – 261
success: change accepted.
set radio-profile auto-tune channel-config
Disables or reenables dynamic channel tuning (RF Auto-Tuning) for the MP radios in a radio
profile.
Syntax
set radio-profile profile-name auto-tune channel-config {enable | disable}
Defaults
Dynamic channel assignment is enabled by default.
Access
Enabled.
History
Usage
If you disable RF Auto-Tuning for channels, MSS does not dynamically set the channels
when radios are first enabled and also does not tune the channels during operation.
If RF Auto-Tuning for channels is enabled, MSS does not allow you to manually change channels.
Even when RF Auto-Tuning for channels is enabled, MSS does not change the channel on radios
that have active client sessions, unless you use the ignore-clients command.
Examples
The following command disables dynamic channel tuning for radios in the rp2 radio
profile:
MX# set radio-profile rp2 auto-tune channel-config disable
success: change accepted.
See Also
● set ap radio channel on page 12-249
● set radio-profile auto-tune channel-holddown on page 12-261
● set radio-profile auto-tune channel-interval on page 12-262
● set radio-profile auto-tune power-config on page 12-264
● show radio-profile on page 12-354
set radio-profile auto-tune channel-holddown
Sets the minimum number of seconds a radio in a radio profile must remain on the current
channel assignment before RF Auto-Tuning can change the channel. The channel holddown
provides additional stability to the network by preventing the radio from changing channels too
rapidly in response to spurious RF anomalies such as short-duration channel interference.
profile-name Radio profile name.
enable Configures radios to dynamically select channels when the radios are started.
disable Configures radios to use statically assigned channels, or the default channels
if unassigned, when the radios are started.
Version 3.0 Command introduced.
Version 5.0 Option no-client added.
Version 6.0 no-client changed to ignore-clients.
Version 7.0 Option ignore-clients moved to a separate
command.