Operation Manual

MP Access Point Commands
Mobility System Software Command Reference Guide
Version 7.3
12 – 260
set radio-profile 11g-only
Deprecated in MSS Version 4.2. To configure radio data rates, see set service-profile
transmit-rates on page 12-312.
set radio-profile 11n
Configures 11n radio ranges on the MP-432.
Syntax set radio-profile profile-name 11n channel-width-na {20MHz | 40MHz}
Defaults None
Access Enabled
History Introduced in MSS 7.0
Examples Use the following command to set the channel width to 40 MHz:
MX# set radio-profile boardroom 11n channel-width-na 40MHz
set radio-profile active-scan
Deprecated in MSS 7.0.
set radio-profile auto-tune 11a-channel-range
When configured, the MP 802.11a radio selects a channel from a limited range of available
channels or all available channels.
Syntax set radio-profile profile-name auto-tune 11a-channel-range
{lower-bands | all-bands}
Defaults lower-bands
Access Enabled
History
Usage
Improves the 802.11a radio usage on the network.
Examples The following command enables the 802.11a radio to select any available channel in the
802.11a range:
MX# set radio-profile test auto-tune 11a-channel-range all-bands
profile-name
Radio profile name
11n channel-width-na
Set the channel width to 20 MHz or 40 MHz
profile-name The name of the radio profile to configure the 802.11a channel range.
lower-bands Only the lower channels are available for the 802.11a radio: 36, 40, 44, 48,
52, 56, 60, or 64.
all-bands All 802.11a channels are available for the 802.11a radio: 36. 40, 44, 48, 52,
56, 60, 64, 149, 153, 157, and 161.
Version 6.0 Command introduced.