Operation Manual

MP Access Point Commands
MP Access Point Commands
12 – 257
History Added in MSS Version 7.1.
Syntax set ap [apnum |auto] tunnel-affinity affinity
set ap upgrade-firmware
Disables or reenables automatic upgrade of an MP boot firmware.
Syntax set ap auto upgrade-firmware {enable | disable}
Defaults Automatic firmware upgrades of MPs are enabled by default.
Access Enabled.
History
Usage
When the feature is enabled on an MX port, an MP connected to that port upgrades the
boot firmware to the latest version stored on the MX.
Examples The following command disables automatic firmware upgrades on the MP connected to
port 9:
MX# set ap 9 upgrade-firmware disable
See Also show ap config radio on page 12-328
set band-preference
Configures MSS to steer clients that support both the 802.11a and 802.11b/g radio bands to a
specific radio on an MP for the purpose of RF load balancing.
apnum Number of the MP to configure for MP-MP tunneling.
auto Enable MP-MP tunneling on all MPs.
tunnel-affinity
affinity
The default value for affinity is 4 with a range of 0 to 10 where 0
indicates that the MP is not used as a tunnel endpoint.
ap auto Configures firmware upgrades for the MP configuration
profile. (See set ap auto on page 12-230.)
enable Enables automatic firmware upgrades.
disable Disables automatic firmware upgrades.
Version 1.0 Command introduced
Version 2.0 Option dap added for Distributed MPs
Version 4.0 Option auto added for configuration of the MP
configuration profile.
Version 6.0 Option dap removed.