Operation Manual
MP Access Point Commands
MP Access Point Commands
12 – 255
Defaults
The default transmit power on all MP radio types is the highest setting allowed for the
country of operation or highest setting supported on the hardware, whichever is lower.
Access
Enabled.
History
Usage
You also can configure a radio channel on the same command line. Use the channel
option.
This command is not valid if dynamic power tuning (RF Auto-Tuning) is enabled.
Examples
The following command configures the transmit power on the 802.11a radio on the MP
access point connected to port 5:
MX# set ap 5 radio 1 tx-power 10
success: change accepted.
The following command configures the channel and transmit power on the 802.11b/g radio on the
MP access point connected to port 11:
MX# set ap 11 radio 1 channel 1 tx-power 10
success: change accepted.
See Also
● set ap radio channel on page 12-249
● show ap config radio on page 12-328
set ap security
Sets security requirements for management sessions between an MX and Distributed MPs.
This feature applies to Distributed MPs only, not to directly connected MPs configured on MP
access ports.
ap apnum Index value that identifies the MP on the MX. You can specify a value from 1
to 9999.
radio 1 Radio 1 of the MP.
radio 2 Radio 2 of the MP. (This option does not apply to single-radio models.)
tx-power
power-level
Number of decibels in relation to 1 milliwatt (dBm). The valid values depend
on the country of operation.
Note: The maximum transmit power you can configure on any Trapeze
Networks radio is the maximum allowed for the country in which you plan to
operate the radio or one of the following values if that value is less than the
country maximum: on an 802.11a radio, 11 dBm for channel numbers less
than or equal to 64, or 10 dBm for channel numbers greater than 64; on an
802.11b/g radio, 16 dBm for all valid channel numbers for 802.11b, or
14 dBm for all valid channel numbers for 802.11g.
Version 1.0 Command introduced
Version 2.0 Option dap added for Distributed MPs
Version 3.0 Default power level changed
Version 6.0 Option dap removed.
Version 6.2 Added the index value range from 1 to 9999.