Operation Manual

MP Access Point Commands
Mobility System Software Command Reference Guide
Version 7.3
12 – 254
set ap radio radio-profile
Assigns a radio profile to an MP radio and enables or disables the radio.
Syntax set ap {apnum | auto} radio {1 | 2}
radio-profile name mode {enable | disable}
Defaults None.
Access Enabled.
History
Usage
When you create a new profile, the radio parameters in the profile are set to the factory
default settings.
To enable or disable all radios using a specific radio profile, use set radio-profile.
Examples The following command enables radio 1 on MP 5 assigned to radio profile rp1:
MX# set ap 5 radio 1 radio-profile rp1 mode enable
success: change accepted.
See Also
● clear ap radio on page 12-225
● set ap radio mode on page 12-253
● set radio-profile mode on page 12-272
● show radio-profile on page 12-354
set ap radio tx-power
Sets the transmit power of an MP radio.
Syntax set ap apnum radio {1 | 2} tx-power power-level
ap apnum Index value that identifies the MP on the MX. You can
specify a value from 1 to 9999.
radio 1 Radio 1 of the MP.
radio 2 Radio 2 of the MP. (This option does not apply to
single-radio models.)
radio-profile
name
Radio profile name of up to 16 alphanumeric characters,
with no spaces.
mode enable Enables radios on the specified ports with the parameter
settings in the specified radio profile.
mode disable Disables radios on the specified ports.
Version 1.0 Command introduced
Version 2.0 Option dap added for Distributed MPs
Version 4.0 Option auto added for configuration of the MP
configuration profile.
Version 6.0 Option dap removed.
Version 6.2 Added index value range from 1 to 9999.