Operation Manual

MP Access Point Commands
MP Access Point Commands
12 – 249
Defaults The default maximum power setting that RF Auto-Tuning can set on a radio is the
highest setting allowed for the country of operation or highest setting supported on the hardware,
whichever is lower.
Access Enabled.
History
Examples
The following command sets the maximum power that RF Auto-Tuning can set on radio
1 on the MP access point on port 7 to 12 dBm.
MX# set ap 7 radio 1 auto-tune max-power 12
success: change accepted.
See Also
● set radio-profile auto-tune power-config on page 12-264
● set radio-profile auto-tune power-interval on page 12-264
set ap radio auto-tune max-retransmissions
Deprecated in MSS Version 5.0.
set ap radio auto-tune min-client-rate
Deprecated in MSS Version 5.0. To configure radio transmit rates, see set service-profile
transmit-rates on page 12-312.
set ap radio channel
Sets an MP radio channel.
Syntax set ap apnum radio {1 | 2} channel channel
radio 2 Radio 2 of the MP. (This option does not apply to single-radio
models.)
power-level Maximum power setting RF Auto-Tuning can assign to the radio,
expressed as the number of decibels in relation to 1 milliwatt
(dBm). You can specify a value from 1 up to the maximum value
allowed for the country of operation.
The power-level can be a value from 1 to 20 or you can set it to
default.
Version 3.0 Command introduced
Version 4.0 Option auto added for configuration of the MP configuration profile.
Version 6.2 Added the index value range of 1 to 9999.
ap apnum Index value that identifies the MP on the MX. You can specify a value from 1
to 9999.
radio 1 Radio 1 of the MP.
radio 2 Radio 2 of the MP. (This option does not apply to single-radio models.)
channel channel Channel number. The valid channel numbers depend on the country of
operation.