Operation Manual

MP Access Point Commands
Mobility System Software Command Reference Guide
Version 7.3
12 – 248
Defaults All radios use the internal antenna by default, if the MP model has an internal antenna.
The MP-620 802.11b/g radio uses model ANT-1360-OUT by default. The MP-620 802.11a radio
uses model ANT-5360-OUT by default. The MP-262 802.11b/g radio uses model ANT1060 by
default.
Access Enabled.
History
Usage
This command applies only to radios on MP models MP-3xx and MP-620 and to the
802.11b/g radio on model MP-262.
Examples The following command configures the 802.11b/g radio on Distributed MP 1 to use
antenna model ANT1060:
MX# set ap 1 radio 1 antennatype ANT1060
success: change accepted.
See Also show ap config radio on page 12-328
set ap radio auto-tune max-power
Sets the maximum power that RF Auto-Tuning can set on a radio.
Syntax set ap {apnum | auto} radio {1 | 2} auto-tune max-power power-level
antennatype
{ANT5060 | ANT5120 |
ANT5180 | internal}
MP-3xx 802.11a external antenna models:
❑ ANT5060—60° 802.11a antenna
❑ ANT5120—120° 802.11a antenna
❑ ANT5180—180° 802.11a antenna
❑ internal—Uses the internal antenna instead
antennatype
{ANT-1360-OUT | ANT-5360-OUT | A
NT-5060-OUT | ANT-5120-OUT | int
ernal}
MP-620 external antenna models:
❑ ANT-1360-OUT—360° 802.11b/g antenna
❑ ANT-5360-OUT—360° 802.11a antenna
❑ ANT-5060-OUT—60° 802.11a antenna
❑ ANT-5120-OUT—120° 802.11a antenna
❑ internal—Uses the internal antenna instead
Version 2.1 Command introduced
Version 3.2
❑ Model numbers added for 802.11a external antennas.
❑ Default changed to internal (except for the MP-262).
Version 4.1 Model numbers added for MP-620 external antennas.
Version 6.2 Added index value range of 1 to 9999.
ap apnum Index value that identifies the MP on the MX. You can specify a
value from 1 to 9999.
ap auto Sets the maximum power for radios configured by the MP
configuration profile. (See set ap auto on page 12-230.)
radio 1 Radio 1 of the MP.