Operation Manual

MP Access Point Commands
Mobility System Software Command Reference Guide
Version 7.3
12 – 246
See Also
● set ap local-switching mode on page 12-244
● clear ap local-switching vlan-profile on page 12-224
● set vlan-profile on page 6-75
set ap name
Changes an MP name.
Syntax set ap apnum name name
Defaults The default name of a directly attached MP is based on the port number of the MP
access port attached to the MP. For example, the default name for an MP on MP access port 1 is
MP01.
Access Enabled.
History
Examples
The following command changes the name of the MP on port 1 to techpubs:
MX# set ap 1 name techpubs
success: change accepted.
See Also show ap config radio on page 12-328
set ap power-mode
Specifies a power mode for the AP.
Syntax set ap apnum power-mode {auto | high}
Defaults None
Access Enabled
History Added in MSS Version 7.1
Usage This command is used mainly for MPs with 802.11n capabilities.
ap apnum Index value that identifies the MP on the MX. You can specify a value from 1
to 9999.
name Alphanumeric string of up to 16 characters, with no spaces.
Version 1.0 Command introduced
Version 2.0 Option dap added for Distributed MPs
Version 4.1 Default Distributed MP name changed from DMPnum to DAPnum
Version 6.0 Option dap removed.
Version 6.2 Added index value range from 1 to 9999.
auto Manages power automatically on the AP.
high Operates the AP at the maximum available power.