Operation Manual

MP Access Point Commands
Mobility System Software Command Reference Guide
Version 7.3
12 – 244
Access Enabled.
History
Usage
After the AirDefense sensor software is copied to the MX, use this command to configure
an MP to load the software. When you do this, the software is transferred to the MP, which then
reboots and comes up as an AirDefense sensor.
Examples The following command causes Distributed MP 1 to load the adconvert.bin file, then
reboot as an AirDefense sensor:
MX# set ap 1 image adconvert.bin
This will change the file a AP will boot. Would you like to continue? (y/n) [n] y
See Also clear ap image on page 12-223
set ap led-mode
Allows you to set the LED behavior on an AP or APs. The setting is active after the AP receives a
configuration from the MX. The blink command has precedence over this command.
Syntax set [apnum | apnum-range | auto] led-mode {auto | static | off}
Defaults Auto
Access Enabled
History Added in MSS 7.1
Usage Used in configurations where the LED activity is undesired.
set ap local-switching mode
Enables local switching for a specified MP.
Syntax set ap apnum local-switching mode {enable | disable}
Version 5.0 Command introduced.
Version 6.0 Option dap removed.
Version 6.2 Added the index value range of 1 to 9999.
auto LEDs are in standard behavior mode.
static LEDs do not flash when traffic is on the network. All
other LED behavior is standard.
off All LEDs are off once the AP is active.
Note:
The following MPs do not support this command:
❑ MP-71
❑ MP-620
❑ MP-622
apnum Index value that identifies the MP on the MX. You can
specify a value from 1 to 9999.