Operation Manual

MP Access Point Commands

Mobility System Software Command Reference Guide

Version 7.3

12 – 242

See Also

● clear ap boot-configuration on page 12-226

● set ap boot-configuration ip on page 12-236

● show ap boot-configuration on page 12-348

set ap fingerprint

Verifies an MP fingerprint on an MX. If MP-MX security is required by an MX, an MP can

establish a management session with the MX only if you have verified the MP identity by

verifying the fingerprint on the MX.

Syntax

set ap apnum fingerprint fingerprint

Defaults

None.

Access

Enabled.

History

Usage

MPs are configured with an encryption key pair at the factory. The fingerprint for the

public key is displayed on a label on the back of the MP, in the following format:

RSA

aaaa:aaaa:aaaa:aaaa:

aaaa:aaaa:aaaa:aaaa

If an MP is already installed and operating, you can use the show ap status command to display

the fingerprint. The show ap config command lists the MP fingerprint only if the fingerprint has

been verified in MSS. If the fingerprint has not been verified, the fingerprint information in the

command output is blank.

Examples

The following example verifies the fingerprint for Distributed MP 8:

MX# set ap 8 fingerprint b4:f9:2a:52:37:58:f4:d0:10:75:43:2f:45:c9:52:c3

success: change accepted.