Operation Manual

MP Access Point Commands
MP Access Point Commands
12 – 233
● set ap radio radio-profile on page 12-254
● set ap upgrade-firmware on page 12-257
set ap auto persistent
Converts a temporary MP configuration created by the MP configuration profile into a persistent
MP configuration on the MX.
Syntax set ap auto persistent [apnum | all]
Defaults None.
Access Enabled.
History I
Usage To display the Distributed MP numbers assigned to Auto-MPs, use the show ap status
all command.
Examples The following command converts the configuration of Auto-AP 10 into a permanent
configuration:
MX# set ap auto persistent 10
success: change accepted.
See Also
● set ap auto on page 12-230
● set ap auto mode on page 12-232
● set ap auto radiotype on page 12-233
●
set ap auto radiotype
Sets the radio type for single-MP radios that use the MP configuration profile.
Syntax set ap auto [radiotype {11a | 11b| 11g}]
Defaults The default radio type for models AP2750, MP-241, and MP-341, and for the 802.11b/g
radios in other models is 802.11g in regulatory domains that support 802.11g, or 802.11b in
regulatory domains that do not support 802.11g.
apnum Index value that identifies the MP on the MX. You can specify a value from 1
to 9999.
all Converts the configurations of all Auto-APs being managed by the MX into
permanent configurations.
Version 4.0 Introduced command.
Version 6.0 Option dap removed.
Version 6.2 Added the index value range of 1 to 9999.
radiotype 11a | 11b | 11g Radio type:
❑ 11a—802.11a
❑ 11b—802.11b
❑ 11g—802.11g