Operation Manual

MP Access Point Commands

Mobility System Software Command Reference Guide

Version 7.3

12 – 232

Examples

The following command creates a profile for automatic Distributed MP configuration:

MX# set ap auto

success: change accepted.

See Also

● set ap auto mode on page 12-232

● set ap auto persistent on page 12-233

● set ap auto radiotype on page 12-233

● set ap bias on page 12-234

● set ap blink on page 12-236

● set ap group on page 12-243

● set ap radio auto-tune max-power on page 12-248

● set ap radio mode on page 12-253

● set ap radio radio-profile on page 12-254

● set ap upgrade-firmware on page 12-257

set ap auto mode

Enables an MX profile for automatic Distributed MP configuration.

Syntax

set ap auto mode {enable | disable}

Defaults

The MP configuration profile is disabled by default.

Access

Enabled.

History

Usage

You must use the set ap auto command to create the profile before you can enable it.

Examples

The following command enables the profile for automatic Distributed MP configuration:

MX# set ap auto mode enable

success: change accepted.