Operation Manual

MP Access Point Commands
MP Access Point Commands
12 – 231
History
Usage Table 12– 2 lists the configurable profile parameters and the default values. The only
parameter that requires configuration is the profile mode. The profile is disabled by default. To use
the profile to configure Distributed MPs, you must enable the profile using the set ap auto mode
enable command.
The profile uses the default radio profile by default. You can change the profile using the set ap
auto radio radio-profile command. You can use set ap auto commands to change settings for
the parameters listed in Table 12– 2. (The commands are listed in the “See Also” section.)
Version 4.0 Command introduced.
Version 4.2 Option persistent added.
Version 5.0
❑ Option force-image-download added.
❑ Option radio num auto-tune min-client-rate
removed.
❑ Option radio num tx-pwr removed.
Version 6.0 Option dap removed.
Version 7.1
❑ Options power-mode, time-out, and
tunnel-affinity added.
Table 12– 2. Configurable Profile Parameters for Distributed MPs
Parameter Default Value
MP Parameters
bias high
blink
(Not shown in show ap
config output)
disable
force-image-download disable (NO)
group (load balancing group) none
led-mode disabled
local-switching disabled
mode disabled
persistent none
power-mode auto
time-out 25 seconds
tunnel-affinity 4
upgrade-firmware
(boot-download-enable)
enable (YES)
Radio Parameters
radio num auto-tune
max-power
default
radio num mode enabled
radio num radio-profile default
radiotype 11g
(or 11b for country codes
where 802.11g is not allowed)