Operation Manual

MP Access Point Commands
Mobility System Software Command Reference Guide
Version 7.3
12 – 230
success: change accepted.
MX# clear service-profile svcprof6
success: change accepted.
● clear radio-profile on page 12-228
● set radio-profile mode on page 12-272
● show service-profile on page 12-357
reset ap
Restarts an MP access point.
Syntax reset ap apnum
Defaults None.
Access Enabled.
History
Usage When you enter this command, the MP drops all sessions and reboots.
Examples The following command resets MP 7:
MX# reset ap 7
This will reset specified AP devices. Would you like to continue? (y/n)y
success: rebooting ap attached to port 7
set ap auto
Creates a profile for automatic configuration of MPs.
Syntax set ap auto
Defaults None.
Access Enabled.
ap apnum Index value that identifies the MP on the MX. You can
specify a value between 1 and 9999.
Version 1.0 Command introduced.
Version 2.0 Option dap added for Distributed MPs.
Version 6.0 Option dap removed.
Version 6.2 Added index value range of 1 to 9999.
W arning!
Restarting an MP can cause data loss for users who are currently associated
with the MP.