Operation Manual

MP Access Point Commands
Mobility System Software Command Reference Guide
Version 7.3
12 – 228
clear radio-profile
Removes a radio profile or resets one of the profile parameters to the default value.
Syntax clear radio-profile name [parameter]
Defaults If you reset an individual parameter, the parameter is returned to the default value
listed in Table 12– 3 on page 273.
Access Enabled.
History
Usage
If you specify a parameter, the setting is reset to the default value. The settings of the
other parameters are unchanged and the radio profile remains in the configuration. If you do not
specify a parameter, the entire radio profile is deleted from the configuration. All radios that use
this profile must be disabled before you can delete the profile.
Examples The following commands disable the radios using radio profile rp1 and reset the
beaconed-interval parameter to the default value:
MX# set radio-profile rp1 mode disable
MX# clear radio-profile rp1 beacon-interval
success: change accepted.
name Radio profile name.
parameter Radio profile parameter:
❑ beacon-interval
❑ countermeasures
❑ dtim-interval
❑ frag-threshold
❑ max-rx-lifetime
❑ max-tx-lifetime
❑ preamble-length
❑ rts-threshold
❑ service-profile
❑ snoop
❑ weighted-fair-queuing
(For information about these parameters, see the set radio-profile
commands that use them.)
Version 1.0 Command introduced.
Version 1.1 Option added to clear individual radio-profile parameter instead of entire
profile.
Version 3.0
❑ Parameters that no longer apply to radio profiles in MSS Version 3.0 removed:
• beaconed-ssid
• clear-ssid
• crypto-ssid
• shared-key-auth
❑ service-profile parameter added.
Version 4.1 countermeasures parameter added.
Version 4.2 Parameters that no longer apply to radio profiles in MSS Version 4.2
removed:
❑ long-retry
❑ short-retry