Operation Manual

MP Access Point Commands
MP Access Point Commands
12 – 227
See Also
● set ap boot-configuration ip on page 12-236
● set ap boot-configuration vlan on page 12-241
● show ap boot-configuration on page 12-348
clear ap radio load-balancing group
Removes an MP radio from a load-balancing group.
Syntax clear ap apnum radio {1 | 2} load-balancing group
Defaults None.
Access Enabled.
History
Usage
If an MP radio has been assigned to an RF load balancing group, you can use this
command to remove the MP radio from the group.
Examples The following command clears radio 1 on MP 7 from the load balancing group to which
it had been assigned:
MX# clear ap 7 radio 1 load-balancing group
MX#
See Also
● set load-balancing strictness on page 12-259
● set ap radio load-balancing on page 12-251
● set ap local-switching mode on page 12-244
● show load-balancing group on page 12-353
ap apnum Index value that identifies the MP on the MX. You can specify a value from 1
to 9999.
radio 1 Radio 1 of the MP.
radio 2 Radio 2 of the MP. (This option does not apply to single-radio models.)
Version 6.0 Command introduced.
Version 6.2 Added index value range of 1 to 9999.