Operation Manual

MP Access Point Commands
Mobility System Software Command Reference Guide
Version 7.3
12 – 226
Access Enabled
History
Usage
When you clear a radio, MSS performs the following actions:
● Clears the transmit power, channel, and external antenna setting from the radio.
● Removes the radio from its radio profile and places the radio in the default radio profile.
This command does not affect the PoE setting.
Examples The following command disables and resets radio 2 on the MP connected to port 3:
MX# clear ap 3 radio 2
See Also
● set ap radio mode on page 12-253
● set ap radio radio-profile on page 12-254
● set port type ap on page 5-59
clear ap boot-configuration
Removes the static IP address configuration for a Distributed MP.
Syntax clear ap apnum boot-configuration
Defaults None.
Access Enabled.
History
Usage
When the static IP configuration is cleared for an MP, and an MP is rebooted, it uses the
standard boot process.
Examples The following command clears the static IP address configuration for MP 1.
MX# clear ap 1 boot-configuration
This will clear specified AP devices. Would you like to continue? (y/n) [n]y
success: change accepted.
Version 1.0 Command introduced.
Version 2.0 Option dap added for Distributed MPs.
Version 5.0
❑ Option antenna-location added.
❑ Option auto-tune min-client-rate removed.
❑ Option auto-tune max-retransmissions removed.
Version 6.0
❑ Option dap removed for distributed MPs.
Version 6.2 Added index value range of 1 to 9999.
ap apnum Index value that identifies the MP on the MX. You can
specify a value from 1 to 9999.
Version 4.2 Command introduced.
Version 6.0 Option dap removed.
Version 6.2 Added a range of 1 to 9999 for index value.