Operation Manual

ManualsBrandsTrapeze smart mobile ManualsSoftwareMobility System Software 7.3

221

222

223

224

225

226

227

228

229

230

MP Access Point Commands

Mobility System Software Command Reference Guide

Version 7.3

12 – 224

Defaults

None.

Access

Enabled.

History

Usage

Use this command to configure an MP that was converted to an AirDefense sensor to

revert back to an MP. When you do this, the next time the MP is booted, it becomes a Trapeze

Mobility Point.

Examples

The following command causes the AirDefense sensor software file to be cleared from

the configuration of MP 1:

MX# clear ap 1 image

success: change accepted.

See Also

set ap image on page 12-243

clear ap local-switching vlan-profile

Clears the VLAN profile that had been applied to an MP to use with local switching.

Syntax

clear ap apnum local-switching vlan-profile

Defaults

None.

Access

Enabled.

History

Usage

A VLAN profile consists of a list of VLANs and tags. When a VLAN profile is applied to an

MP, traffic for the VLANs specified in the VLAN profile is locally switched by the MP instead of

being tunneled back to an MX.

Use this command to reset the VLAN profile used by the MP for local switching to the default

VLAN profile. Traffic that was locally switched because of an entry in the cleared VLAN profile is

tunneled to an MX.

When clearing a VLAN profile causes traffic that was locally switched by MPs to be tunneled to an

MX, the sessions of clients associated with the MPs with the VLAN profile are terminated, and

the clients must re-associate with the MPs.

Examples

The following command clears the VLAN profile that was applied to MP 7:

MX# clear ap 7 local-switching vlan-profile

success: change accepted.