Operation Manual

MP Access Point Commands
MP Access Point Commands
12 – 223
clear ap image
Clears an AirDefense sensor software image file from the configuration on an MP.
Syntax clear ap apnum image
Updated set ap power-mode on page 12-246
Updated set ap radio channel on page 12-249
set ap radio tx-power on page 12-254
set ap image on page 12-243
set ap led-mode on page 12-244
clear ap radio on page 12-225
show ap config radio on page 12-328
show ap status on page 12-340
show ap counters on page 12-330
show ap global on page 12-351
show ap connection on page 12-349
show ap unconfigured on page 12-352
show ap qos-stats on page 12-336
show ap etherstats on page 12-338
MP Local Switching set ap local-switching mode on page 12-244
set ap local-switching vlan-profile on page 12-245
clear ap local-switching vlan-profile on page 12-224
show ap arp on page 12-326
show ap fdb on page 12-335
show ap vlan on page 12-344
WLAN Mesh Services set ap boot-configuration mesh mode on page 12-237
set ap boot-configuration mesh psk-phrase on
page 12-238
set ap boot-configuration mesh psk-raw on
page 12-238
set ap boot-configuration mesh ssid on page 12-239
set service-profile mesh on page 12-299
set service-profile bridging on page 12-290
show ap boot-configuration on page 12-348
show ap mesh-links on page 12-339
AirDefense
Integration
set ap image on page 12-243
clear ap image on page 12-223
ap apnum Index value that identifies the MP to the MX. You can specify a
value between 1 and 9999.