Operation Manual

Network Domain Commands
Mobility System Software Command Reference
Version 7.3
11 – 216
success: change accepted.
The following command sets the MX as a member of a Network Domain with a seed that has the
IP address 192.168.9.254 and sets the affinity for that seed to 7. If the MX specifies other Network
Domain seeds, and they are configured with the default affinity of 5, then 192.168.9.254 becomes
the primary Network Domain seed for the MX.
MX# set network-domain mode member seed-ip 192.168.9.254 affinity 7
success: change accepted.
See Also
● clear network-domain on page 11-213
● show network-domain on page 11-217
set network-domain peer
On a Network Domain seed, configures one or more MX switches as redundant Network Domain
seeds. The seeds in a Network Domain share information about the VLANs configured on the
member devices, so that all the Network Domain seeds have the same database of VLAN
information.
Syntax set network-domain peer peer-ip
Defaults None.
Access Enabled.
History Introduced in MSS 4.1.
Usage This command must be entered on an MX configured as a Network Domain seed.
Examples The following command sets the MX with IP address 192.168.9.254 as a peer of this
Network Domain seed:
MX# set network-domain peer 192.168.9.254
success: change accepted.
See Also
● clear network-domain on page 11-213
● show network-domain on page 11-217
set network-domain mode seed domain-name
Creates a Network Domain by setting the current MX as a seed device and naming the Network
Domain.
Syntax set network-domain mode seed domain-name net-domain-name
Defaults None.
Access Enabled.
History Introduced in MSS 4.1.
ip-addr IP address of the Network Domain seed to specify as a peer, in dotted decimal
notation.
net-domain-name Name of the Network Domain. Specify between 1 and
16 characters with no spaces.