Operation Manual

Mobility Domain Commands

Mobility System Software Command Reference Guide

Version 7.3

10 – 210

Examples

The following command configures this MX as the secondary seed in a Mobility Domain

named Pleasanton:

MX# set mobility-domain mode secondary-seed domain-name Pleasanton

mode is: secondary-seed

domain name is: Pleasanton

See Also

● clear mobility-domain member on page 10-205

● show mobility-domain on page 10-212

set mobility-domain mode seed domain-name

Creates a Mobility Domain by setting the current MX as the seed device and naming the Mobility

Domain.

Syntax

set mobility-domain mode seed domain-name mob-domain-name

Defaults

None.

Access

Enabled.

History

Usage

Before you use this command, the current MX must have an IP address set with the set

system ip-address command. After you enter this command, all Mobility Domain traffic is sent

and received from the specified IP address.

You must explicitly configure only one MX per domain as the seed. All other MX switches in the

domain receive their Mobility Domain information from the seed.

Examples

The following command creates a Mobility Domain named Pleasanton with the current

MX as the seed:

MX# set mobility-domain mode seed domain-name Pleasanton

mode is: seed

domain name is: Pleasanton