Operation Manual

Mobility Domain Commands
Mobility System Software Command Reference Guide
Version 7.3
10 – 206
Defaults None
Access Enabled.
History .
Usage You must enable cluster mode on all MXs that are members of the cluster.
Examples The following command enables cluster mode on an MX in a mobility domain:
MX# set cluster mode enable
success: change accepted.
set cluster preempt
Use this command on the secondary seed of the cluster to allow the secondary seed to become
active if the primary seed fails.
Syntax set cluster preempt [enable | disable]
Defaults None
Access Enabled
History Introduced in MSS 7.0.
Usage You can only use this command on the secondary seed of the mobility domain.
Examples The following command enables preempt mode on a secondary seed:
MX# set cluster preempt enable
success: change accepted.
set domain security
Enables MX-MX security on the MX Mobility Domain.
Syntax set domain security {none | required}
Defaults The default is none. (MX-MX security is disabled.)
Access Enabled.
History Introduced in MSS 5.0.
Usage The setting must be the same (none or required) on all switches, the seed and all
members, in the Mobility Domain.
The set domain security none command is equivalent to the clear domain security
command.
Examples The following command enables MX-MX security on an MX:
MX# set domain security required
MSS 7.0 Command introduced.
MSS 7.3 restore-backup-config deprecated.
none MX-MX security is disabled.
required MX-MX security is enabled.