Operation Manual

Mobility Domain Commands
Mobility Domain Commands
10 – 205
Syntax clear mobility-domain ap-affinity-group [address ipaddr netmask netmask |
ip/netmask]
Defaults None
Access Enabled.
History Introduced in MSS 7.1
clear mobility-domain member
On the seed MX, the command removes the identified member from the Mobility Domain.
Syntax clear mobility-domain member ip-addr
Defaults None.
Access Enabled.
History Introduced in MSS 1.0.
Usage This command has no effect if the MX member is not configured as part of a Mobility
Domain or the current MX is not the seed.
Examples The following command clears a Mobility Domain member with the IP address
192.168.0.1:
MX-20# clear mobility-domain member 192.168.0.1
See Also set mobility-domain member on page 10-207
load configuration cluster
Load a previous cluster configuration on the MX.
Syntax load configuration cluster filename
Defaults None
Access Enabled
History Introduced in MSS Version 7.0
Usage This command is only allowed on a Mobility Domain member when Virtual Controller
Cluster is enabled.
set cluster mode
Enable cluster configuration on MXs in a mobility domain.
Syntax set cluster mode [enable | disable [restore-backup-config]]
ip-addr IP address of the Mobility Domain member, in dotted decimal notation.
enable Enables cluster mode.
disable Disables cluster mode after the feature is enabled.