Operation Manual

Mobility Domain Commands 10 – 203
10
Mobility Domain Commands
Use Mobility Domain commands to configure and manage Mobility Domain groups.
A Mobility Domain is a system of MXs and MPs working together to support a roaming user
(client). One MX acts as a seed MX, which maintains and distributes a list of IP addresses of the
domain members.
Smart Cluster is a network resiliency feature added in MSS 7.0. It has the following features:
❑ Centralized configuration of MXs and MPs.
❑ Autodistribution of configuration parameters to MPs.
❑ “Hitless” failover on the network if an MX is unavailable.
❑ Automatic load balancing of MPs across any MXs in the cluster.
This chapter presents Mobility Domain commands alphabetically. Use the following table to
locate commands in this chapter based on their use.
Note:
The number of MPs supported on a cluster member is limited to the number
supported on an MX. It is recommended to use larger capacity MXs, such as
MX-200s, MX-216s, or MX-2800s in your configuration to obtain the maximum
benefits of cluster configuration.
Note:
Trapeze Networks recommends that you run the same MSS version on all the MX
switches in a Mobility Domain and Smart Cluster.
Mobility Domain set mobility-domain mode seed domain-name on page 10-210
set domain security on page 10-206
set mobility-domain ap-affinity-group on page 10-207
set mobility-domain member on page 10-207
set mobility-domain mode member seed-ip on page 10-208
show mobility-domain on page 10-212
show mobility-domain config on page 10-212
clear mobility-domain ap-affinity-group on page 10-204
clear mobility-domain member on page 10-205
clear domain security on page 10-204
clear mobility-domain on page 10-204
Virtual
Controller
Cluster
load configuration cluster on page 10-205
set cluster mode on page 10-205
set cluster preempt on page 10-206