Operation Manual

System Services Commands
System Services Commands
4 – 23
quit Exit from the Admin session
radping Send requests to RADIUS server
reset Reset, use 'reset help' for more information
restore Restore system information from file name (or url)
rfping Rfping operations
rmdir Remove a directory created by mkdir
rollback Remove changes to the edited ACL table
run Evaluate contents of a cli file
save Save the running configuration to persistent storage
set Set, use 'set help' for more information
show Show, use 'show help' for more information
telnet telnet IP address [server port]
traceroute Print the route packets take to network host
uninstall Uninstall sygate on-demand agent files
upgrade Upgrade Resiliency Cluster
See Also “Using CLI Help” on page 2–10
history
Displays the command history buffer for the current CLI session.
Syntax history
Defaults None.
Access All.
History Introduced in MSS Version 1.0.
Examples To show the history of your session, type the following command:
MX> history
Show History (most recent first)
--------------------------------
[00] show config
[01] show version
[02] enable
See Also clear history on page 4-20
quickstart
Runs a script that interactively helps you configure a new MX.
(For more information, see the Mobility System Software Quick Start Guide.)
set auto-config
Enables an MX switch to contact a RingMaster server for its configuration.
!
Caution
The quickstart command is for configuration of a new MX only. After
prompting you for verification, the command erases the MX configuration
before continuing. If you run this command on a MX with a configuration,
the configuration is erased. In addition, error messages such as Critical AP
Notice for directly connected MPs can appear.