Operation Manual

System Services Commands
Mobility System Software Command Reference Guide
Version 7.3
4 – 22
Examples To clear the location of the MX, type the following command:
MX# clear system location
success: change accepted.
See Also
● set system contact on page 4-30
● set system countrycode on page 4-30
● set system idle-timeout on page 4-34
● set system ip-address on page 4-35
● set system location on page 4-35
● show config on page 21-499
● show system on page 4-40
help
Displays a list of commands that can be used to configure and monitor the MX.
Syntax help
Defaults None.
Access All.
History Introduced in MSS Version 1.0.
Examples Use this command to see a list of available commands. If you have restricted access, you
see fewer commands than if you have enabled access. To display a list of CLI commands available
at the enabled access level, type the following command at the enabled access level:
MX# help
Commands:
-------------------------------------------------------------------------
backup Backup system information to filename (or url)
clear Clear, use 'clear help' for more information
commit Commit the content of the ACL table
copy Copy from filename (or url) to filename (or url)
crypto Crypto, use 'crypto help' for more information
delete Delete url
dir Show list of files on flash device
disable Disable privileged mode
exit Exit from the Admin session
help Show this help screen
history Show contents of history substitution buffer
install Install sygate on-demand agent
ldap-ping test binding to a LDAP server or server-group
load Load, use 'load help' for more information
logout Exit from the Admin session
monitor Monitor, use 'monitor help' for more information
md5 md5 filename
mkdir Create a subdirectory on flash device
monitor monitor port counters
ping Send echo packets to hosts
quickstart Perform an initial configuration
Version 7.1 Option mx-secret added.
Version 7.3 Option console-timeout added.