Operation Manual

System Services Commands
System Services Commands
4 – 21
See Also set prompt on page 4-28. (For information about default prompts, see “Command
Prompts” on page 2–5.)
clear run
Clear the rule associated with scriptname.
Syntax clear run scriptfilename
Defaults None
Access Enabled
History Added in MSS 7.1.
Examples To clear the script, runmem, use the following command:
MX# clear run runmem
success: change accepted.
clear system
Clears the system configuration of the specified information.
Syntax clear system [console-timeout | contact | countrycode | idle-timeout |
ip-address | location | mx-secret |name]
Defaults None.
Access Enabled.
History
W arning!
If you change the IP address, any currently configured Mobility Domain operations
cease. You must reset the Mobility Domain.
console-timeout Clears the configured timeout for the CLI.
contact Resets the name of contact person for the MX to null.
countrycode Resets the country code for the MX to null.
idle-timeout Resets the number of seconds a CLI management session can remain idle to
the default value (3600 seconds).
ip-address Resets the IP address of the MX to null.
location Resets the location of the MX to null.
mx-secret Clears the MX secret from the system.
name Resets the name of the MX to the default system name, which is
MX-mm-nnnnnn, where mm is the model number and nnnnnn is the
last 6 digits of the switch’s MAC address.
Version 1.0 Command introduced.
Version 4.1 Option idle-timeout added.