Operation Manual

AAA Commands
AAA Commands
9 – 163
success: change accepted.
See Also
❑ clear accounting on page 9-148
❑ show accounting statistics on page 9-199
set accounting command
Provides the ability to log all CLI commands to an external server for auditing purposes. The
following capabilities are available:
❑ All successfully completed commands are logged.
❑ Commands are logged to an external RADIUS server or servers.
❑ Password/key data is obscured.
❑ Configuration is handled as an additional RADIUS accounting type:
❑ VSA 13
Each command accounting message contains the following information:
❑ Timestamp
❑ tty port
❑ Username
❑ Source IP address
❑ Command issued
❑ Command status (success/failure)
Syntax set accounting command radius-server-group
Defaults None
Access Enabled
History Added in MSS 7.1
Examples To begin command auditing and logging commands to the RADIUS server group,
corpsecure, use the following command:
MX# set accounting command corpsecure
success: change accepted.
set accounting system
Configures MSS to send Accounting-On and Accounting-Off messages to a specified RADIUS
server group.
Syntax set accounting system method1 [method2] [method3] [method4]
Defaults By default MSS does not send Accounting-On or Accounting-Off messages.
Access Enabled.
History Introduced in MSS 5.0.
method1
method2
method3
method4
At least one of up to four methods that MSS uses to process
accounting records. Specify one or more methods in priority
order. If the first method does not succeed, MSS tries the
second method, and so on.
Note: The local method is not valid for this command.