Operation Manual

IP Services Commands
IP Services Commands
8 – 141
See Also
● clear ntp server on page 8-96
● clear summertime on page 8-99
● clear timezone on page 8-100
● set ntp on page 8-114
● set ntp server on page 8-114
● set summertime on page 8-128
● set timezone on page 8-130
● show timezone on page 8-144
show snmp configuration
This command is deprecated in MSS Version 4.0. Use the show snmp status command instead.
show snmp community
Displays the configured SNMP community strings.
Syntax show snmp community
Defaults None.
Access Enabled.
History Introduced in MSS Version 4.0.
Current time System time that was current on the MX when you pressed Enter after typing
the show ntp command.
Timezone Time zone configured on the switch. MSS offsets the time reported by the NTP
server based on the time zone.
Note: This field is displayed only if you change the time zone.
Summertime Summertime period configured on the switch. MSS offsets the system time +1
hour and returns it to standard time for daylight savings time or a similar
summertime period that you set.
Note: This field is displayed only if you enable summertime.
Last NTP update Time when the MX received the most recent update from an NTP server.
NTP Server IP address of the NTP server.
Peer state State of the NTP session from the point of view of the NTP server:
❑ CORRECT
❑ REJECT
❑ SELCAND
❑ SYNCCAND
❑ SYSPEER
Local state State of the NTP session on the MX NTP client:
❑ INITED
❑ START
❑ SYNCED
Table 8– 7. Output for show ntp (continued)
Field Description