Operation Manual

IP Services Commands
Mobility System Software Command Reference Guide
Version 7.3
8 – 140
See Also
● clear ip telnet on page 8-95
● set ip https server on page 8-109
● set ip telnet on page 8-112
● set ip telnet server on page 8-113
● show ip https on page 8-137
show ntp
Displays NTP client information.
Syntax show ntp
Defaults None.
Access All.
History
Examples
To display NTP information for an MX, type the following command:
MX> show ntp
NTP client: enabled
Current update-interval: 20(secs)
Current time: Fri Feb 06 2004, 12:02:57
Timezone is set to 'PST', offset from UTC is -8:0 hours.
Summertime is enabled.
Last NTP update: Fri Feb 06 2004, 12:02:46
NTP Server Peer state Local State
---------------------------------------------------
192.168.1.5 SYSPEER SYNCED
Table 8– 7 describes the fields in this display.
Table 8– 6. Output for show ip telnet
Field Description
Server Status State of the HTTPS server:
❑ Enabled
❑ Disabled
Port TCP port number that the MX listens for Telnet management traffic.
Version 1.0 Command introduced
Version 2.0 Peer State and Local State fields added
Table 8– 7. Output for show ntp
Field Description
NTP client State of the NTP client. The state can be one of the following:
❑ Enabled
❑ Disabled
Current update-interval Number of seconds between queries sent by the MX to the NTP servers for
updates.