Operation Manual

IP Services Commands
Mobility System Software Command Reference Guide
Version 7.3
8 – 130
success: set ip address 10.10.20.20 netmask 255.255.255.0 on vlan taupe
MX# set system ip-address 10.10.20.20
success: change accepted.
See Also
● clear system ip-address on page 8-99
● set interface on page 8-102
● show system on page 4-40
set timedate
Sets the time of day and date on the MX.
Syntax set timedate {date mmm dd yyyy [time hh:mm:ss]}
Defaults None.
Access Enabled.
History Introduced in MSS Version 1.0.
Usage The day of week is automatically calculated from the day that you set. The time displayed
by the CLI after you type the command might be slightly later than the time entered due to the
interval between pressing Enter and when the CLI reads and displays the new time and date.
Configure summertime before you set the time and date. Otherwise, the summertime adjustment
makes the time incorrect, if the date is within the summertime period.
Examples The following command sets the date to March 13, 2003 and time to 11:11:12:
MX# set timedate date feb 29 2004 time 23:58:00
Time now is: Sun Feb 29 2004, 23:58:02 PST
See Also
● clear summertime on page 8-99
● clear timezone on page 8-100
● set summertime on page 8-128
● set timezone on page 8-130
● show summertime on page 8-143
● show timedate on page 8-144
● show timezone on page 8-144
set timezone
Sets the number of hours, and optionally, the number of minutes, that the MX real-time clock is
offset from Coordinated Universal Time (UTC). These values are also used by Network Time
Protocol (NTP), if it is enabled.
date mmm dd yyyy System date:
❑ mmm—month.
❑ dd—day.
❑ yyyy—year.
time hh:mm:ss System time, in hours, minutes, and seconds.